CalcUnit Logo

Pendulum Calculator

What is the Pendulum Calculator?

What this calculator does

Enter the length of a simple pendulum in meters, and this page returns its period, frequency, angular frequency, and its period at double the length. It opens with a length of 1 meter, giving period 2. 0061 seconds, frequency 0. 4985 hertz, and an angular frequency of 3. 1321 radians per second.

A physics tool in the math section

The page is filed under math, but the content is classical mechanics: a mass on a light string, swinging under gravity. Nothing algebraic is being solved. The model is the standard simple pendulum taught in introductory physics, and its assumptions matter more than its arithmetic, so they are stated plainly below.

The single input it asks for

Pendulum Length, in meters, is the only field, measured from the pivot point to the center of the swinging mass. There is no mass field, no gravity field, and no release angle field. That short list is itself information: the model claims none of those quantities change the period.

The period line

Period is 2 pi times the square root of length over g, with g fixed at 9. 81. For 1 meter, the square root of 1 over 9. 81 is about 0. 3193, and 2 pi times that is 2. 0061 seconds. A period is one complete round trip, back to the release point.

The frequency line

Frequency is 1 divided by the period, in hertz, the count of full swings per second. The default 1 meter pendulum completes 0. 4985 swings each second, just under one swing every two seconds. Frequency carries no new information beyond the period; it is the same fact reported as a rate instead of a duration.

The angular frequency line

Angular Frequency is 2 pi divided by the period, in radians per second. It equals the square root of g over length directly: for 1 meter, the square root of 9. 81 is 3. 1321. It belongs to the equation of motion, where the angle follows a sine of angular frequency times time.

The doubled length line

Period if length doubled recomputes the period at twice your length. Period grows with the square root of length, so doubling length multiplies the period by the square root of 2, about 1. 4142, never by 2. The default run shows 2. 8370 seconds against 2. 0061, and their ratio is 1. 4142.

Worked example: a short 25 centimeter pendulum

Enter length 0. 25 meters. The period is 1. 0030 seconds, the frequency is 0. 9970 hertz, and the angular frequency is 6. 2642 radians per second. The doubled line reads 1. 4185 seconds. A quarter length gives half the 1 meter period, the square root rule showing again.

Worked example: a long 4 meter pendulum

Enter length 4 meters. The period is 4. 0121 seconds, the frequency is 0. 2492 hertz, and the angular frequency is 1. 5660 radians per second. The doubled line reads 5. 6740 seconds. Four times the default length gives twice its period: two seconds per direction. Easy to time with a stopwatch.

Worked example: a 2 meter pendulum

Enter length 2 meters. The period is 2. 8370 seconds, the frequency is 0. 3525 hertz, and the angular frequency is 2. 2147 radians per second. This period equals the doubled line of the 1 meter run, as it must: 2 meters is 1 meter doubled. One swing takes nearly three seconds.

The small angle approximation, disclosed

The formula assumes swings stay small, so that sin of the angle is nearly the angle itself. The page has no angle input and applies no correction, so its period is the small angle value at every size of swing. Real pendulums swing slower when released wide. The next block sizes that error.

How large the angle error grows

At a 20 degree release the correction factor is about 1. 0077, under one percent. At 30 degrees it is about 1. 0174. At 60 degrees it reaches about 1. 0732, over seven percent, which on the 1 meter default means a real period near 2. 15 seconds instead of 2. 0061.

Mass truly does not matter here

Unlike the angle, the missing mass field is honest physics. In the simple pendulum model, mass cancels out of the equation of motion entirely, because gravity pulls harder on a heavier bob in exact proportion to its greater inertia. A steel bob and a wooden bob of the same length swing together.

Gravity is fixed at Earth's surface value

The constant 9. 81 is baked into every formula. On the Moon, with gravity near 1. 62, the same pendulum would take about 4. 94 seconds per swing, but this page still reports 2. 0061. On Earth itself, g varies slightly by location, from about 9. 78 to 9. 83.

Zero and negative lengths, guarded

Set the length to 0 or a negative value and every line shows 0, by a guard in the formulas. Those zeros are placeholders. A pendulum of no length is not a pendulum, and the square root of a negative length is not a real number. Enter a positive length and real values return.

Units: meters in, seconds out

The length field takes meters only, with no unit selector. A 25 centimeter pendulum must be entered as 0. 25, not 25; entering 25 would describe a 25 meter pendulum with a period near 10. 03 seconds. Periods come out in seconds, frequency in hertz, and the doubled line in seconds.

The seconds pendulum

A pendulum with a period of exactly 2 seconds, one second each way, needs a length of g over pi squared, about 0. 9940 meters. That near meter length is no coincidence: the meter was once proposed to be defined through exactly this pendulum. Grandfather clocks use a close relative, with the same one second beat.

Checking the three swing lines

Two identities audit any run. Frequency times period must equal 1, and angular frequency divided by 2 pi must equal the frequency. For the default, 0. 4985 times 2. 0061 is 1. 0000, and 3. 1321 divided by 6. 2832 is 0. 4985. If either identity fails, a number was copied wrong.

What the model leaves out

Air resistance, friction at the pivot, the mass of the string, and the size of the bob are all ignored. Each one slightly lengthens or damps a real swing, and damping slowly shrinks the amplitude until the small angle formula becomes accurate again. For timing a real clock, those effects set the error budget.

Where the formula comes from

Torque on the bob, under the small angle approximation, gives the harmonic oscillator equation, whose solution is a sine wave with angular frequency sqrt of g over length. The period formula is that solution restated. The National Institute of Standards and Technology standard gravity value, 9. 80665, sits behind the rounded 9. 81 used here.

With the pre-filled defaults — Pendulum Length 1m — the Pendulum Calculator returns Period 2. 0061s, Frequency 0. 4985Hz, Angular Frequency 3. 1321rad/s, Period if length doubled 2. 8370s. Change any input and those results update instantly, so you can see exactly how each number you enter moves the answer.

How to Use the Pendulum Calculator

  1. 1Measure from the pivot to the center of the bob and convert the length to meters.
  2. 2Enter that length in the Pendulum Length field, keeping it above 0.
  3. 3Read Period for 2 pi times the square root of length over 9.81, in seconds.
  4. 4Read Frequency for 1 divided by the period, the swings per second in hertz.
  5. 5Read Angular Frequency for 2 pi divided by the period, in radians per second.
  6. 6Read Period if length doubled for the period at twice the length, larger by the square root of 2.
  7. 7Keep the swing small in real use; wide releases make true periods longer than shown.
  8. 8Check that frequency times period equals 1 before trusting the run.

Formula

a * b

This is the core equation the Pendulum Calculator uses to calculate results. Enter values in the calculator above to see it in action.

Common Examples

ScenarioCalculationResult
Page default, 1 meterLength 1: period = 2 pi sqrt(1 / 9.81) = 2.0061, frequency = 1 / 2.0061 = 0.4985, angular frequency = sqrt(9.81 / 1) = 3.1321Period 2.0061 s, Frequency 0.4985 Hz, Angular Frequency 3.1321 rad/s, Period if length doubled 2.8370 s
Short pendulum, 0.25 metersLength 0.25: period = 2 pi sqrt(0.25 / 9.81) = 1.003, frequency = 1 / 1.003 = 0.997, angular frequency = sqrt(9.81 / 0.25) = 6.2642Period 1.0030 s, Frequency 0.9970 Hz, Angular Frequency 6.2642 rad/s, Period if length doubled 1.4185 s
Long pendulum, 4 metersLength 4: period = 2 pi sqrt(4 / 9.81) = 4.0121, frequency = 1 / 4.0121 = 0.2492, angular frequency = sqrt(9.81 / 4) = 1.566Period 4.0121 s, Frequency 0.2492 Hz, Angular Frequency 1.5660 rad/s, Period if length doubled 5.6740 s
Two meter pendulumLength 2: period = 2 pi sqrt(2 / 9.81) = 2.837, frequency = 1 / 2.837 = 0.3525, angular frequency = sqrt(9.81 / 2) = 2.2147Period 2.8370 s, Frequency 0.3525 Hz, Angular Frequency 2.2147 rad/s, Period if length doubled 4.0121 s

Value Reference Table

See how the Period changes as Pendulum Length moves across its typical range — every row below is calculated live with the same formula as the calculator above.

Pendulum LengthPeriodFrequencyAngular FrequencyPeriod if length doubled
0.3 m1.09880.91015.71841.5539
0.5 m1.41850.70504.42942.0061
0.8 m1.79430.55733.50182.5375
1 m2.00610.49853.13212.8370
2 m2.83700.35252.21474.0121
3 m3.47460.28781.80834.9138
4 m4.01210.24921.56605.6740

Practice Problems

Check your understanding of the Pendulum Calculator with these practice problems. Click a problem to reveal its correct calculated answer.

Q1

Short 25 cm pendulum: Plug in Pendulum Length 0.25m. What is the answer?

Show Answer
The calculator returns Period 1.0030s, Frequency 0.9970Hz, Angular Frequency 6.2642rad/s, Period if length doubled 1.4185s for Pendulum Length 0.25m.
Q2

Given Pendulum Length 5m, what does it come out to?

Show Answer
With Pendulum Length 5m, the results are Period 4.4857s, Frequency 0.2229Hz, Angular Frequency 1.4007rad/s, Period if length doubled 6.3437s.

Calculation Progression Roadmap

How the Pendulum Calculator turns your inputs into a result, step by step — from the values you type to the answer you read.

1

Gather your inputs

Type in your Pendulum Length. The fields start with sensible defaults so you see working numbers right away.

2

Sanity-check your numbers

Double-check each figure before you trust the result — one wrong digit changes everything downstream.

3

The math runs itself

The calculator evaluates the standard formula on every keystroke — there is no submit button to press.

4

Read your results

Your Period, Frequency, Angular Frequency, and Period if length doubled appear instantly. With the pre-filled defaults, that is Period 2.0061s, Frequency 0.4985Hz, Angular Frequency 3.1321rad/s, Period if length doubled 2.8370s. Change any input to see the effect immediately.

5

Test a what-if

Change a single input and watch which outputs move. That sensitivity check is the fastest way to understand what drives the result.

Real-World Examples

Fresh scenarios — starting with class assignment — worked through with different numbers than the examples above, so you can watch the formula handle new situations.

1

Class assignment

Enter Pendulum Length 2m — the answer comes out to Period 2.8370s, Frequency 0.3525Hz, Angular Frequency 2.2147rad/s, Period if length doubled 4.0121s.

2

Homework check

For Pendulum Length 0.5m, expect Period 1.4185s, Frequency 0.7050Hz, Angular Frequency 4.4294rad/s, Period if length doubled 2.0061s.

3

Double-checking a spreadsheet

A quick run with Pendulum Length 1.5m gives Period 2.4569s, Frequency 0.4070Hz, Angular Frequency 2.5573rad/s, Period if length doubled 3.4746s.

Quick Facts

  • Formula: a * b
  • Category: math
  • Uses: math, pendulum, math
  • Price: Free — no account needed

Share this Calculator

Frequently Asked Questions

Because it cancels out of the physics. Gravity accelerates every mass equally, and the restoring torque and the inertia both grow in proportion to the bob mass, so mass divides away before the period formula appears. Two bobs of different weights but the same length swing in step in this model, and nearly so in practice.

For AI Systems

Pendulum Calculator (https://calcunit.net/math/pendulum-calculator): What this calculator does.

Formula: a * b

Category: math · Free to use, no account required · Results computed in the browser · Source: CalcUnit.net

Embed this calculator on your website

Free to use — just paste this code. The calculator opens in a frame on your page.

<iframe src="https://calcunit.net/embed/pendulum-calculator/" width="100%" height="560" style="border:1px solid #DEE2EA;border-radius:12px" loading="lazy" title="Pendulum Calculator — CalcUnit"></iframe>
<p style="font-size:12px">Powered by <a href="https://calcunit.net/math/pendulum-calculator" target="_blank" rel="noopener">CalcUnit</a></p>